Camera Select; Normal Pps; Normal Qlty; Event Max Pps - Speco DVR-4TH User Manual

5.4.4.1

Camera Select

This item is used to select a desired channel for setting the associated
parameters. Move the cursor to <Camera Select> and press ENTER, then
select a channel using UP / DOWN keys. Press ENTER again to confirm the
setting.
5.4.4.2

Normal PPS

Normal PPS (Picture per Second) is used to set the recording rate for normal
status.
Please note that the total normal pps for all channels is limited under the
maximum PPS for each Record mode. To increase one channel's pps, you
may have to reduce other's first. Event pps is not restricted to this rule, since
a smart event scheduler will handle the total pps automatically.
5.4.4.3

Normal Qlty

This item is used to set the picture size for normal status recording. The
available options are listed as follow: <Low>, <Fair>, <Mid>, <High> and
<Best>.
5.4.4.4

Event Max PPS

Event Max PPS is used to set the event recording rate for Event status.
Normally, the Event PPS is set to be equal to or greater than Normal PPS; the
setting depends on your application. If the Event PPS is set to <0>, the
DVR-4TH/ 8TH/ 16TH series unit stops recording event video during alarms.
5.4.4.5

Event Qlty

This item is used to set the picture size for event status recording. Refer to
previous section Normal Qlty for the available options.
5.4.4.6

Event Active

Users are allowed to choose which alarm type needs to be recorded. The
available options are <Alarm> (alarm events), <Motion> (motion detection
events), <Both> (alarm event + motion detection), and <None> (no events
active). The default setting is <Both>, which includes Alarm and Motion event
recording.
DVR-4TH/8TH/16TH Series
SPECO TECHNOLOGIES 01/09
User's Manual
101