EnGenius EOC1650
L2TP Pass Through: Place a check in this box if you would like to enable this pass through.
Layer 2 Tunneling Protocol is a transport protocol that enables tunneling through the
Internet for the establishment of virtual private networks.
IPSec Pass Through: Place a check in this box if you would like to enable this pass through.
IPSec is a VPN protocol used to implement secure exchange of packets at the IP layer.
Click on the Apply button to save the changes.
7.5 Wireless
7.5.1 Wireless Network
The Wireless Network page allows you to configure the wireless mode, channel, SSID, and
security settings.
Wireless Mode: Depending on the type of wireless clients that are connected to the
network, you may select B, G, or B/G‐mixed. If you are not sure about which clients will be
accessing the wireless networks, it is recommended that you select B/G‐mixed for the best
performance.
SSID: The SSID is a unique named shared amongst all the points of the wireless network. The
SSID must be identical on all points of the wireless network and cannot exceed 32 characters.
You may specify an SSID or select one from the Site Survey.
Site Survey: Click on the Site Survey button in order to scan the 2.4GHz frequency for
devices that broadcast their SSID. Click on the BSSID link to connect to the Access Point.
Click on the Refresh button to re‐scan the frequency.
Wireless Access Point / Client Bridge
Click on the Wireless link on the navigation drop‐down
menu. You will then see three options: wireless
network, wireless security, and wireless advanced
settings. Each option is described below.
Version 2.0
64