EnGenius EOC1650
Read‐Only Community Name: Specify the password for access the SNMP community for
read only access.
Read‐Write Community Name: Specify the password for access to the SNMP community
with read/write access.
Trap Destination IP Address: Specify the IP address of the computer that will receive the
SNMP traps.
Trap Destination Community Name: Specify the password for the SNMP trap community.
Click on the Apply button to save the changes.
6.5.3 Backup/Restore settings, Reset to factory default settings
Click on the Backup/Restore Setting link under the Management menu. This option is used
to save the current settings of the device in a file on your local disk or load settings on to the
device from a local disk. This feature is very handy for administrators who have several
devices that need to be configured with the same settings.
Save a copy of the current settings: Click on the Backup button to save the current
configuration.
Restore saved settings from a file: Once a file has been backed up, you may restore it by
clicking on the Browse button to select the file, and then the Restore button.
Revert to factory default settings: Click on the Factory Default Settings button to reset the
device to the default settings. Please wait while the device restart and then access the
device using the default IP address: 192.168.1.1
6.5.4 Firmware Upgrade
Click on the Upgrade Firmware link under the Management menu. This page is used to
upgrade the firmware on the device. Make sure that downloaded the appropriate firmware
from your vendor.
Wireless Access Point / Client Bridge
Version 2.0
51