Wan - Ppp O E - EnGenius EOC1650 User Manual

EnGenius EOC1650
Internet Connection Type: Select the Static IP from the drop‐down list.
Account Name: Specify an account name if your ISP has provided you with one.
Domain Name: Specify a domain name if the ISP has provided you with one.
MTU: The Maximum Transmission Unit (MTU) is a parameter that determines the largest
packet size (in bytes) that the router will send to the WAN. If LAN devices send larger
packets, the router will break them into smaller packets. Ideally, you should set this to
match the MTU of the connection to your ISP. Typical values are 1500 bytes for an Ethernet
connection and 1492 bytes for a PPPoE connection. If the router's MTU is set too high,
packets will be fragmented downstream. If the router's MTU is set too low, the router will
fragment packets unnecessarily and in extreme cases may be unable to establish some
connections. In either case, network performance can suffer.
IP Address: Specify the IP address for this device, which is assigned by your ISP.
Subnet Mask: Specify the subnet mask for this IP address, which is assigned by your ISP.
Gateway IP Address: Specify the IP address of the default gateway, which is assigned by
your ISP.
Domain Name Service: Specify the primary and secondary DNS server IP address.
Click on the Apply button to save the changes.
7.4.1.3 WAN – PPPoE
The WAN interface can be configured as PPPoE. This type of connection is usually used for a
DSL service and requires a username and password to connect.
Wireless Access Point / Client Bridge Version 2.0
60