EnGenius EOC1650
IP Network Setting: Select Obtain an IP address automatically (DHCP) radio button if the
Access Point is connected to a DHCP server. This will allow the Access Point to pass IP
addresses to the clients associated with it. You may select Specify an IP Address radio
button if you would like the device to use a static IP address. In this case, you would be
required to specify an IP address, subnet mask, and default gateway IP address.
IP Address: Specify an IP address
IP Subnet Mask: Specify the subnet mask for the IP address
Default Gateway: Specify the IP address of the default gateway.
Click on the Apply button to save the changes.
6.3.3 Spanning Tree Settings
Click on the Spanning Tree link under the System drop‐down menu Spanning‐Tree Protocol
is a link management protocol that provides path redundancy while preventing undesirable
loops in the network.
Spanning Tree Status: Choose to enable or disable the spanning tree feature.
Bridge Hello Time: Specify the number of seconds for the hello time.
Bridge Max Age: Specify the number of seconds for the max age.
Bridge Forward Delay: Specify the number of seconds for the bridge forward delay.
Priority: Specify the number of seconds for the priority.
Click on the Apply button to save the changes.
6.4 Wireless
Wireless Access Point / Client Bridge
Click on the Wireless link on the navigation drop‐down
menu. You will then see four options: Wireless
Network, WDS Link Settings, WDS Security and
Wireless Advanced Settings. Each section is described
in detail below.
Version 2.0
46