Configuring Wireless Printing Using Fingerprint - Intermec PB50 User Manual

Chapter 2 — Configuring the Mobile Printer
40

Configuring Wireless Printing Using Fingerprint

Use the following procedures to configure your printer with
Fingerprint for wireless printing.
To configure the printer to use WEP authentication
1 Send the following commands to login as an administrator and set
the SSID:
run"su -p pass admin"
setup write "wlan","uart1:"
setup "wlan","SSID",
where xxxxx can be from 0 to 32 ASCII characters, not including
the double quote.
Note: The default password for logging in as an admin is "pass."
If you have changed the password, you will need to use your
password instead of "pass."
2 Send the following commands to configure the WEP keys. The
following example sets WEP key 1 to 1234 and enables WEP key 1.
setup "wlan","WEP1","0x0001020304"
setup "wlan",".WEP_KEY","1"
setup "wlan","ACTIVE","1"
setup write "wlan","uart1:"
To configure the printer to use WPA-PSK or WPA2-PSK mode
1 Send the following commands to login as an administrator and set
the SSID:
run"su-p pass admin"
setup write "wlan","uart1:"
setup "wlan","SSID","
where xxxxx can be from 0 to 32 alphanumeric characters.
2 Send one of the following WPA/WPA2 ON commands to turn on
WPA or WPA2 authentication. Send the WPA-PSK or WPA2-PSK
command to set a pre-shared key:
setup "wlan","WPA","ON"
setup "wlan","WPA2","ON"
setup "wlan","WPA_PSK","
setup "wlan","ACTIVE","1"
setup write "wlan","uart1:"
where xxxxxxxxxx is a value between 8 and 64 characters.
"xxxxx
"
xxxxx
"
xxxxxxxxxx
"
PB50 and PB51 Mobile Printer User Guide