Intermec PB50 User Manual page 53

PB50 and PB51 Mobile Printer User Guide
To configure the Printer to use WPA or WPA2 Enterprise mode
1 Send the following commands to login as an administrator and set
the SSID:
run"su-p pass admin"
setup write "wlan","uart1:"
setup "wlan","SSID","
where xxxxx can be from 0 to 32 alphanumeric characters.
2 Send one of the following WPA/WPA2 ON commands to set up
WPA-802.1x or WPA2-802.1x authentication. You should also
send the WPA_PSK command that does not contain a value:
setup "wlan","WPA","ON"
setup "wlan","WPA2","ON"
setup "wlan","WPA_PSK",""
setup write "wlan","uart1:"
• To view the 802.1x values, send this command:
setup write "8021x","uart1:"
3 Send these commands to configure the EAP_TYPE:
setup "8021x","EAP_TYPE","
where xxxx can be OFF, LEAP, PEAP, or TTLS.
setup "8021x",".EAP_USER","
setup "8021x","EAP_PASS","
where xxxx is the unique username and the unique password for
this protocol.
4 If you are using TTLS, you may need to send this command to set
the TTLS outer name:
setup "8021x","TTLS_USER","
where xxxx is the outer name.
5 If you are using certificates for authentication, here are some
commands you may need to use.
• Send the following commands to set a certificate and enable
validation:
setup "8021x","CA_CERT","
setup "8021x","VALIDATE","ON"
where c:/test.pfx is the location and name of the certificate and
export is the passphrase.
Chapter 2 — Configuring the Mobile Printer
xxxxx
"
xxxx
"
xxxx
"
xxxx
"
xxxx
"
c:/test.pfx
@
export
"
41