Configuring 802.11 Wireless Security Using Fingerprint - Intermec PM4i User Manual

Chapter 2 — Connecting the Printer
50

Configuring 802.11 Wireless Security Using Fingerprint

Use the following procedures to configure 802.11 wireless security
parameters on your printer using Fingerprint.
To configure the printer to use WEP authentication
1 Send the following commands to login as an admin and set the
SSID:
run"su -p pass admin"
setup write "wlan","uart1:"
setup "wlan","SSID","xxxxx"
where xxxxx can be from 0 to 32 ASCII characters, not including
the double quote.
To enter non-alphanumeric octets, use "%nn," where nn is two
hexadecimal digits representing the value of the character
Note: The default password for logging in as an admin is "pass."
If you have changed the password, you will need to use your
password instead of "pass."
2 Send the following commands to configure the WEP keys.
The following example sets WEP key 1 to 01234 and enables
WEP key 1.
setup "wlan","WEP1","0x3031323334"
setup "wlan",".WEP_KEY","1"
setup "wlan","ACTIVE","1"
setup write "wlan","uart1:"
To configure the printer to use WPA-PSK or WPA2-PSK mode
1 Send the following commands to login as an admin and set the
SSID:
run"su-p pass admin"
setup write "wlan","uart1:"
setup "wlan","SSID","xxxxx"
where xxxxx can be from 0 to 32 alphanumeric characters.
To enter non-alphanumeric octets, use "%nn," where nn is two
hexadecimal digits representing the value of the character
Note: The default password for logging in as an admin is "pass."
If you have changed the password, you will need to use your
password instead of "pass."
PM4i Mid-Range Printer User's Manual