The Printer - Intermec PB50 User Manual

Chapter 2 — Configuring the Mobile Printer
36
4 From the host PC, check the wireless settings.
If you have an IPL version of the printer, send these commands to

the printer:

<STX><SI>wt,SSID<ETX>
<STX><SI>wt,WEP1<ETX>
<STX><SI>wt,WEP2<ETX>
<STX><SI>wt,WEP3<ETX>
<STX><SI>wt,WEP4<ETX>
<STX><SI>wt,AUTH<ETX>
<STX><SI>wt,WPA<ETX>
<STX><SI>wt,WPA2<ETX>
<STX><SI>wt,WPA_PSK<ETX>
<STX><SI>wt,ROAM<ETX>
<STX><SI>wt,PWR_MODE<ETX>
<STX><SI>wt,CHANNEL<ETX>
<STX><SI>wt,AP_MAC<ETX>
<STX><SI>wt,SIGNAL<ETX>
<STX><SI>wt,SPEED<ETX>
<STX><SI>wt,ACTIVE<ETX>
If you have a Fingerprint version of the printer, send this
command to the printer:
setup write "wlan","uart1:"
5 Configure the printer to use the correct SSID and authentication
mode.
6 If you use a certificate for wireless authentication and encryption,
transfer the certificate to the printer. The printer can accept .pfx,
.pem, and .der certificates.
7 Verify that the printer is connected to the access point and make
sure it can get an IP address.
Understanding the 802.11 Radio Icons
Icon Description
Excellent signal
Strong signal
Good signal
PB50 and PB51 Mobile Printer User Guide