Intermec PB50 User Manual page 47

PB50 and PB51 Mobile Printer User Guide
5 If your wireless access point uses DHCP, select Get TCP/IP
parameters automatically. If the access point does not use
DHCP, select Use the following TCP/IP parameters and type
the device IP Address, Network Mask, Default Router (default
gateway), and Name Server (primary DNS server). Click Next.
6 Type the SSID (Network Name). For peer-to-peer access points,
select This is an ad hoc network and select the Channel you
want to use. The channel setting must be the same on all wireless
devices on the ad-hoc network. Click Next.
7 Select the security options required to connect to your wireless
network. Click Next.
8 If you selected Static WEP, Dynamic WEP (802.1x), or Wi-Fi
Protected Access in Step 7, type the WEP keys or network
credentials required for authentication. Click Next.
9 Wait for PrintSet to apply your settings. Click Next, then click
Finish to complete the wizard.
To set up the printer for wireless communications using a
communications program
1 Connect the 8-pin circular DIN connector to the serial port on the
printer.
2 Connect the other end of the serial cable to a serial port on the
back of your PC or to a serial adapter on your mobile computer.
3 Open a communications program such as HyperTerminal on your
PC and configure the following parameters for the serial port:
Parameter
Baud rate
Data bits
Parity
Stop bits
Chapter 2 — Configuring the Mobile Printer
Default Setting
115200
8
None
1
35