Chapter 3 — Troubleshooting and Maintaining the Mobile Printer
Restarting the Mobile Printer
64
To start Dump mode from Ready mode with IPL
Press and hold the Feed and Standby buttons until the printer
•
starts feeding out media.
The printer feeds several labels (or inches of media), prints the test
labels, and then starts Dump mode.
To stop Dump mode
•
Press the Feed button.
You rarely need to cold boot the printer unless you are upgrading the
firmware. If your printer occasionally locks up, you will want to cold
boot it. A cold boot restarts the 802.11 wireless radio and clears the
working memory.
Note: The Setup menu is not affected by a cold boot. Your printer
retains all of your configuration settings after the printer powers back
up.
To restart the printer
1 Disconnect the printer from power if externally powered.
2 Remove the battery from the printer for at least one second.
3 Insert the battery back into the printer.
4 Reconnect external power if your printer is externally powered.
PB50 and PB51 Mobile Printer User Guide