Understanding the Printer Sounds
Using the Batteries
PB50 and PB51 Mobile Printer User Guide
Note: You cannot configure ESC/P from the Setup menu. If your
printer is originally in ESC/P and you want to change to Fingerprint
or IPL, you need to enter Exteded Test Mode and select the printer
language. For more information, see
Mode" on page
25.
The printer plays sounds in response to several actions that you can
perform. Use the following table to understand when the sounds
occur and what they mean.
Understanding the Printer Sounds
Sound
Occurs When:
•
Power
•
Hardware
You open the media door, close the media door, or insert a
cable.
Button
You press any of the printer buttons.
•
Error
•
The printer uses a rechargeable 2200 mAh lithium-ion battery (Model
AB13) for power. You must fully charge the battery before you can use
the printer. When in Standby mode, a fully charged battery can last up
to one week without recharging.
Use Intermec Model AB13 battery only. Use of another battery
may present a risk of fire or explosion.
The Model AB13 battery may present a fire or chemical burn
hazard if mistreated. Do not disassemble, heat above 100 °C
(212 °F), or incinerate.
Chapter 1 — Using the Mobile Printer
"Understanding Extended Test
You connect the AC power cable or insert a battery.
The printer starts charging the battery.
The printer cannot feed paper or print a job because of
a hardware issue such as the media door open, a paper
jam, or there is no media.
An error occurs such as a paper jam or a print error.
9