Configuring Wireless Printing Using Fingerprint - Intermec PB31 User Manual

PB21 and PB31 Mobile Receipt Printer User Guide
• Send this command to make sure your values match those
used by the access point:
<STX><SI>wt,[variable name]<ETX>
All variables are returned with the exception of EAP_PASS
which always returns "****" if configured and CA_CERT
which transmits the name of the last certificate authority
successfully installed. An additional read-only variable for the
supplicant state, called STATE, is also returned.
• You may need to send this command several times for the
wireless station to connect:
<STX><SI>ws,ACTIVE,1<ETX>

Configuring Wireless Printing Using Fingerprint

Use these procedures to configure your printer with Fingerprint for
wireless printing.
To configure the printer to use WEP authentication
1 Send these commands to login as an admin and set the SSID:
run"su -p pass admin"
setup write "wlan","uart1:"
setup "wlan","SSID","xxxxx"
where xxxxx can be from 0 to 32 alphanumeric characters.
Note: The default password for logging in as an admin is "pass." If
you changed the password, you need to use your password instead
of "pass."
2 Send these commands to configure the WEP keys. This example
sets WEP key 1 to 1234 and enables WEP key 1.
setup "wlan","WEP1","0x0001020304"
setup "wlan",".WEP_KEY","1"
setup "wlan","ACTIVE","1"
setup write "wlan","uart1:"
Chapter 2 — Configuring the PB21 and PB31
39