Intermec PB50 User Manual page 71

PB50 and PB51 Mobile Printer User Guide
Chapter 3 — Troubleshooting and Maintaining the Mobile Printer
Possible Printer Error Icons and Messages
Error Icon Error Message
Pause
Paper out (IPL)
Out of Paper
(Fingerprint)
Testfeed not
done
Printhead hot
'
Upgrading
LSS too high
LSS too low
IP configuration
error
IP link error
Description
The print job is paused.
The printer is out of paper. Load a new roll of
media. For help, see "Loading Media" on
page 14.
The printer did not perform a testfeed before
it printed out test labels. It is important to
perform a testfeed because it calibrates the
printer sensors.
To perform a testfeed:
•
Press the Feed button for more than 2
seconds (Fingerprint or ESC/P)
•
Open and close the media door, then press
the Feed button (IPL)
The printhead is overheated and needs to
cool down. In IPL, wait for printing to resume
automatically. In Fingerprint and ESC/P,
your print job is lost.
The printer is loading new firmware.
These errors can occur when you run a test
feed without any media installed, or if you
have incorrect media settings.
Load the printer with media (see
Media" on page 14), run Test mode (see
"Understanding Extended Test Mode" on
page 25), and select the appropriate media
type.
The printer does not have a network IP
address. Wait for the printer to acquire an IP
address before continuing.
The printer does not have a network
connection.
"Loading
59