Understanding Extended Test Mode - Intermec PB50 User Manual

Understanding Extended Test Mode

PB50 and PB51 Mobile Printer User Guide
3 Release the buttons. The printer performs a test feed (sensor
calibration), prints a series of test labels, and then starts Dump
mode.
While in Dump mode, information received by the printer is
printed immediately.
4 Press Feed to stop Dump mode.
After you stop Dump mode, the printer returns to Ready mode. For
more information on additional options available in Dump mode
with IPL, see "Troubleshooting Communication Problems" on
page 62.
Use Extended Test mode to run additional diagnostic tests or resolve
more difficult problems, including printing specific test labels,
starting Dump mode, and resetting the printer to factory default
settings.
TEST LABELS
CHESS
Sample Extended Test Mode Screen
To start Extended Test mode
1 Make sure that the printer is loaded with media.
2 Press the media cover release button to open the media cover.
3 Press the Standby button to turn the printer off.
4 Press the Feed and Standby buttons at the same time until
CLOSE PRINTER DOOR appears on the screen.
5 Close the media cover. You are now in Extended Test mode.
• Press to select the next function or option.
• Press to start the current function.
• Press to stop Extended Test mode.
Chapter 1 — Using the Mobile Printer
25