Setting The Frequency Reference - Omron EasySpeed 3G3JE User Manual

Operation
3-4-2 Selecting the Item to be Displayed
Changing the Display Item
■
• The Mode Key can be pressed to change the display item in the order shown below.
• The display item can be change during operation or when operation is stopped.
Display Key
sequence
Frequency ref-
erence
Output fre-
quency
Output current
Accumulated
operating time
Forward/
reverse opera-
tion selection
Note The
@ RVS indicator will not light when forward operation is set
If reverse operation is set, the @ RVS indicator will light and rev will be displayed
data display
.
on the data display.
3-4-3 Changing the Frequency Reference
Range for Changing the Frequency Reference
■
• The frequency reference is set in increments of 0.1 Hz for less than 100 Hz and in increments of
1 Hz at 100 Hz or higher. The setting range for the frequency reference is between the frequency
reference upper limit (P07) and the frequency reference lower limit (P08) set in the initial settings
mode. (Set the frequency reference upper limit and frequency reference lower limit in initial settings
mode.)

Setting the Frequency Reference

■
• The frequency reference can be set during operation or while operation is stopped.
3-10
Indicator Display
example
@ Hz set
60.0
@ Hz out
0.0
@ A
0.0
@ Kh
0.0
None (See
note.)
fwd
(@ RVS)
Explanation
The entire display and simplified-LED indi-
cators will light (except for the COM indica-
tor) when the power supply is turned ON.
The present frequency reference will be
displayed on the data display.
When the Mode Key is pressed while the @
Hz set indicator is lit, the output frequency
will be displayed. At the same time the @
Hz out indicator will light.
When the Mode Key is pressed while the @
Hz out indicator is lit, the present output
current will be displayed. At the same time
the @ A indicator will light.
When the Mode Key is pressed while the @
A indicator is lit, the present accumulated
operating time will be displayed. At the
same time the @ Kh indicator light will light.
When the Mode Key is pressed while the
@ Kh indicator is lit, the present direction of
rotation will be displayed. No indicator will
light.
and fwd will be displayed on the
Chapter 3