Omron EasySpeed 3G3JE User Manual page 39

Design
1. When connecting one solderless terminal to each terminal, use the following size
Terminal Tightening
screw size torque
(N·m)
M3 0.5 to 0.6
2. When connecting two solderless terminals to each terminal, use the following size.
Terminal Tightening
screw size torque
(N·m)
M3 0.5 to 0.6
3. When connecting one 2-wire (twin) solderless terminal to each terminal, use the following size.
Terminal Tightening
screw size torque
(N·m)
M3 0.5 to 0.6
● Wiring Method
Wire the control I/O terminals using the following procedure.
1. Loosen the terminal screws with a thin flat-blade screwdriver.
2. Insert the wires from underneath the terminal block.
3. Tighten the terminal screws to the torque specified in the previous table.
Note Applying a torque that is greater than the specified torque may damage the terminal block. If
the tightening torque is insufficient, however, it may cause malfunction or short circuiting.
Wire Solderless terminal
size (mm
Stranded 0.25 to 1.5
wire
Wire Solderless terminal
size (mm
Stranded 0.25 to 0.5
wire
Wire Solderless terminal
size (mm
Stranded 0.5 to 1
wire
Thin flat-blade screwdriver
Strip the end for approx.
6 mm if a solderless
terminal is not used.
Wires
Insulating
2 sleeve
)
With/without
Insulating
2 sleeve
)
Without
Insulating
2 sleeve
)
With
Terminal block
Attach solderless terminal
or wire without soldering.
Chapter 2
.
Recommended
solderless terminal
model
(Mfd. by Phoenix
Contact)
AI 0,25-6 BU
AI 0,34-8 TQ
AI 0,5-8 WH
AI 0,75-8 GY
AI 1-8 RD
AI 1,5-8 BK
Recommended
solderless terminal
model
(Mfd. by Phoenix
Contact)
A 0,5-6
Recommended
solderless terminal
model
(Mfd. by Phoenix
Contact)
AI-TWIN 2x0,5-8 WH
AI-TWIN 2x0,75-8 GY
AI-TWIN 2x1-8 RD
2-17