Multitech FaxFinder FF130 Administrator's Manual page 47

Field
___Mode Code
Fax Direction Use this to specify if this modem line is for inbound faxes only, outbound faxes only,
or both. This setting should match the setting of the analog line/equipment
connected to this port. If the modem has a Fax Direction of outbound, but the
PBX/Telco line connected to it is set to inbound, FaxFinder will not answer inbound
calls.
Routing If you selected a vendor pre-defined routing code, it displays in this field. If you
Definition selected User Defined for Routing, enter your own formula/definition in this field.
Routing Definition identifies code elements sent by the PBX so that FaxFinder can
mask information it doesn't need and identify the extension number it does need.
Key
Description Click this link for an explanation of the current mode code, if any, in the
Error Select On to use T.30 error correction with this modem or Off to disable it. Default is
Correction On.
Max Baud Rate Select the maximum connection (baud) rate that allowed on the modem. Default is
14400.
Smart Dial Select On to enable Smart Dial or Off to disable it. When Smart Dial is enabled, the
modem waits to detect a dial tone before dialing.
FaxFinder Administrator User Guide
Description
PBX Mode Code routing is similar to DTMF Digits, except the
DTMF digits/tones coming from the PBX contain additional
information the FaxFinder doesn't use. FaxFinder needs to know
the format of incoming mode codes to identify and extract the
DID extension number imbedded within in.
FaxFinder includes PBX Mode Codes for some device
manufacturers. If the codes for your device are not included,
select User Defined and add the code to the Routing Definition
field.
Click Key for information on the definition.
●
n is the variable number for each definition
●
For Call Type, Calling Number, and Internal Code, replace n with the
number of digits that you want masked or ignored.
●
For Extension digits, replace n with the number of extension digits
used to route inbound faxes to recipients.
●
If you are using a predefined mode code that use $x? as the
Extension Digits variable, use the Max DTMF Digits field to define
the number of DID extension digits.
Routing Definition field.
Chapter 3: FaxFinder Web Management Interface
47