Installing; Adjustable Back Upholstery; Adjustable Tension Straps; Back Upholstery Cover - Invacare ProSPIN X4 Owner's Manual

Hide thumbs Also See for ProSPIN X4:

Table of Contents

SECTION 9—BACK

Installing

1. Install the new back upholstery over mounted back cane.

2. Slide the loose back cane through the new back upholstery.

3. Using the mounted back cane as a guide, reinstall the loose back cane to the

wheelchair frame with the existing back height adjustment screw and locknut.

NOTE: For proper installation of the back upholstery, the back canes MUST be mounted in the

same height adjustment hole.

4. Secure the new back upholstery to the back canes with the two mounting screws and

washers. Torque to 20‐25 in‐lbs.

5. Secure the bottom of the new back upholstery to the wheelchair frame with tie‐wraps.

Mounting Screw

Washers

Mounting Screw

FIGURE 9.5 Removing/Installing the Standard Back Upholstery

The adjuster straps can be adjusted at various levels of tension to accommodate

individual end‐users. In a typical scenario, the bottom two straps can be adjusted tightly

to support and/or assist the extensor muscles.

The back upholstery cover is designed for three reasons:

1. The first is as a modesty cover.

2. The second is to keeps the cushion from sliding out of the back of the wheelchair.

3. The third is a sacral support depending upon how far or tight the seat portion of the

back upholstery is pulled under the seat cushion.

ProSPIN™ X4™

Back Upholstery

Remove Back Cane

Part No 1125104

Table of Contents