SECTION 13—ANTI-TIPPERS
Installing/Removing the Anti-Tipper Bracket
NOTE: For this procedure, refer to FIGURE 13.2.
NOTE: Reverse this procedure to remove the anti‐tipper bracket.
NOTE: The anti‐tipper bracket is secured to the wheelchair frame with the same mounting screws
used to mount the axle plate and any camber spacers present. Installing or removing the anti‐tipper
bracket may require a different length mounting screw. Refer to Adjusting the Rear Wheel Camber
on page 70 to ensure proper mounting screw length.
1. Remove the rear wheels. Refer to Removing/Installing Rear Wheels on page 67.
2. Remove the two existing bottom mounting screws and locknuts that secure the axle
plate and any camber spacers present to the wheelchair frame.
3. Insert two new bottom mounting screws through the axle plate and any camber
spacers present.
4. Position anti‐tipper bracket onto bottom mounting screws and tightly secure using
two locknuts.
5. Repeat STEPS 2‐4 to install remaining anti‐tipper mounting bracket.
6. Install rear wheels. Refer to Removing/Installing Rear Wheels on page 67.
Wheelchair Frame
Axle Plate
Bottom Mounting
Screws
FIGURE 13.2 Installing/Removing the Anti-Tipper Bracket
ProSPIN™ X4™
Camber Spacer(s)
88
Locknuts
Anti-tipper
Bracket
Part No 1125104