Adding/Removing Or Changing Height Adjustment Spacers; Removing/Installing The Fork Assembly; Removing Fork Assembly/Height Adjustment Spacers - Invacare ProSPIN X4 Owner's Manual

Hide thumbs Also See for ProSPIN X4:

Table of Contents

SECTION 12—CASTERS, FORK AND FORK STEM ASSEMBLIES

Adding/Removing or Changing Height Adjustment

Spacers

NOTE: Height adjustment spacers are part of the fork assembly. To perform this procedure, refer

to Removing/Installing the Fork Assembly on page 82.

NOTE: For this procedure, refer to FIGURE 12.4 on page 83.

NOTE: Both the standard and suspension forks remove/install in the same way.

NOTE: 2‐inch spacers are not used with suspension style forks.

NOTE: If replacing a fork, note the mounting position of the existing front caster for installation

of the new fork.

NOTE: If changing the fork size and/or adding/removing or changing height adjustment spacers,

refer to Changing Front Seat‐to‐Floor Height on page 93 to determine the hardware needed for the

required front seat‐to‐floor height.

NOTE: Both forks MUST be the same size.

1. Remove the front caster from the fork. Refer to Removing Front Caster on page 79.

2. Perform one of the following:

• Standard Forks ‐ Remove locknut and washer securing the fork, spacer and height

adjustment spacer (if present) from the stem bolt (Detail "A").

• Suspension Fork (Detail "B") ‐

a. Refer to Removing the Elastomer on page 86 to remove the elastomer and

suspension fork bottom to access the locknut and washer.

b. Remove locknut and washer securing the suspension fork top, spacer and

height adjustment spacer (if present) from the stem bolt.

3. Remove stem bolt from fork stem.

ProSPIN™ X4™

Part No 1125104

Table of Contents

Troubleshooting