Adjusting The Anti-Tipper Height; Adjusting The Anti-Tipper - Invacare ProSPIN X4 Owner's Manual

Adjusting the Anti-tipper Height

The anti‐tipper height can be adjusted two ways:
Adjusting the Anti‐tipper ‐ Positioning the wheeled portion of the anti‐tipper up or down
to meet the 1½ to 2‐inch clearance. Refer to Adjusting the Anti‐tipper on page 89.
Adjusting the Anti‐tipper Bracket ‐ Changing the anti‐tipper bracket mounting position
and/or angle to meet the 1½ to 2‐inch clearance. Refer to Adjusting the Anti‐tipper Bracket
on page 90.
Although both adjustments may be necessary to meet the 1½ to 2‐inch clearance
requirement, it is recommended to adjust the anti‐tipper first before adjusting the anti‐
tipper bracket.

Adjusting the Anti-tipper

NOTE: For this procedure, refer to FIGURE 13.3.
1. Press the spring button on the wheeled
portion of the anti‐tipper and slide it up
or down to achieve a 1‐½ to 2‐inch
clearance.
2. Check to make sure that the spring
buttons are fully engaged in
adjustment holes.
3. If 1½ to 2‐inch clearance cannot be
achieved adjust the anti‐tipper bracket.
Refer to Adjusting the Anti‐tipper
Bracket on page 90.
Part No 1125104
SECTION 13—ANTI-TIPPERS
Release Button
1½ to 2-inch Clearance
FIGURE 13.3 Adjusting the Anti-tipper
89
Anti-tipper
(Wheels)
ProSPIN™ X4™