Installing/Removing Elevating Legrests; Installing; Removing; Raising/Lowering The Elevating Legrest - Invacare ProSPIN X4 Owner's Manual

SECTION 4—WHEELCHAIR OPERATION

Installing/Removing Elevating Legrests

NOTE: For this procedure, refer to FIGURE 4.5.

Installing

1. Place elevating legrest on the outside of the wheelchair and insert mounting pin into
the mounting tube.
2. Rotate elevating legrest toward the inside of the wheelchair until it locks in place.
NOTE: The calfpad of the legrest will be on the
inside of the wheelchair when locked in place.
3. Repeat STEPS 1‐3 for the other
elevating legrest assembly.

Removing

1. Push the legrest release handle inward
while rotating the elevating legrest
outward.
2. Lift the legrest assembly out of the
mounting tube of the wheelchair frame.
3. Repeat STEPS 1‐2 for opposite side, if
necessary.

Raising/Lowering the Elevating Legrest

NOTE: For this procedure, refer to
FIGURE 4.6.
1. Perform one of the following:
• Raising: Lift legrest assembly up to
desired height.
• Lowering: Lift elevating legrest
assembly up with one hand. While
supporting the elevating legrest
assembly (and user's leg), pull
release lever up with other hand
and lower legrest assembly to
desired height.
ProSPIN™ X4™
Mounting Pin
Release
Handle
Mounting
Tube
NOTE: The mounting tube will be part of
the seat frame or wheelchair front frame
depending on wheelchair model.
FIGURE 4.5 Installing/Removing Elevating
Elevating Legrest
Assembly
FIGURE 4.6 Raising/Lowering the Elevating
30
Elevating
Legrest
Inside of
Wheelchair
Legrests
Release Lever
Legrest
Part No 1125104