Adjusting Swingaway Padded Armrest Height - Invacare ProSPIN X4 Owner's Manual

Adjusting Swingaway Padded Armrest Height

NOTE: For this procedure, refer to FIGURE 8.10.
1. Remove the half arm from the arm socket.
2. Remove the mounting bolt, two washers and locknut mounted in the arm socket that
determine the swingaway padded armrest height.
3. Reposition mounting bolt and one washer to one of three positions in the arm socket
depending on the desired height.
4. Retighten the mounting bolt and washer to the arm socket with the remaining washer
and locknut.
5. Reinstall the half arm into the arm socket.
6. Repeat STEPS 1‐5 for the opposite side, if necessary.
Three Mounting Positions
FIGURE 8.10 Adjusting Swingaway Padded Armrest Height
Part No 1125104
Swingaway Padded Armrest
Washer
Locknut
Arm Socket
Washer
55
SECTION 8—ARMS
Mounting Bolt
ProSPIN™ X4™