Changing Wheel Lock Handle Position; Converting Wheel Lock From Push-To-Lock To Pull-To-Lock Or Pull-To-Lock To Push-To-Lock; Converting From Push-To-Lock To Pull-To-Lock - Invacare ProSPIN X4 Owner's Manual

SECTION 6—WHEEL LOCKS
Push-to-Lock or Pull-to-Lock Wheel Locks
Mounting Screws
Wheel Lock
FIGURE 6.1 Replacing/Adjusting the Wheel Locks

Changing Wheel Lock Handle Position

NOTE: For this procedure, refer to FIGURE 6.2.
1. Loosen, but DO NOT remove, the rear handle mounting screw.
2. Remove the front handle mounting
screw and locknut.
3. Align the front handle mounting hole
with one of three desired mounting
positions on the wheel lock.
4. Using the front handle mounting screw
and locknut, secure the handle to the
wheel lock.
5. Securely tighten the front and rear
handle mounting screws and locknuts.
6. Repeat STEPS 1‐5 on remaining wheel
lock handle.
Converting Wheel Lock From Push-to-Lock to
Pull-to-Lock or Pull-to-Lock to Push-to-Lock
NOTE: For this procedure, refer to FIGURE 6.3 on page 39.

Converting From Push-to-Lock to Pull-to-Lock

1. Remove set screw from the lower stop position (Detail "A").
ProSPIN™ X4™
3/16 inch
(1/8-inch)
Wheel
Lock
Tire
Shoe
Rear Handle
Mounting
FIGURE 6.2 Changing Wheel Lock Handle
38
Under Mount Wheel Lock
Mounting Screws
Wheel Lock
Wheel lock Handle
Screw
Position
3/16 inch
(1/8-inch)
Wheel
Lock
Tire
Shoe
Mounting
Positions
Front Handle
Mounting
Screw and
Locknut
Part No 1125104