Installing Fork Assembly/Height Adjustment Spacers - Invacare ProSPIN X4 Owner's Manual

Installing Fork Assembly/Height Adjustment Spacers

NOTE: Stem bolt length based on set‐to‐floor height, refer to Changing Front Seat‐to‐Floor Height
on page 93 to ensure proper stem bolt length before installing the fork assembly.
1. Insert stem bolt through fork stem.
2. Perform one of the following:
• Standard Forks ‐ Using a locknut and washer, secure the height adjustment spacer
(if needed), spacer and fork to the stem bolt (Detail "A").
• Suspension Fork (Detail "B") ‐
a. Using a locknut and washer, secure the height adjustment spacer (if needed),
spacer and suspension fork top to the stem bolt
b. Refer to Installing the Elastomer on page 86 secure the suspension fork top to
the elastomer and suspension fork bottom.
3. Install the front caster. Refer to Installing Front Caster on page 79.
DETAIL "A"
STANDARD FORK
Fork Stem
Height Adjustment
Spacer (If used)
Fork
Locknut
FIGURE 12.4 Removing/Installing the Fork Assembly
Part No 1125104
SECTION 12—CASTERS, FORK AND FORK STEM ASSEMBLIES
DETAIL "B"
SUSPENSION FORK
Stem Bolt
Fork Stem
Suspension Fork Top
Spacer
Washer
Washer
Locknut
Elastomer
Mounting Screws
83
Spacer
Stem Bolt
Height Adjustment
Spacer (If used)
Threaded Bushing
Mounting
Screws
Suspension
Fork Bottom
ProSPIN™ X4™