Permanent Axles; Adjusting Quick-Release Axles - Invacare ProSPIN X4 Owner's Manual

SECTION 11—WHEELS

Permanent Axles

1. Remove the mounting bolt and locknut that secure the rear wheel to the axle bushing.
2. Remove the rear wheel.
3. Repeat STEP 1‐2 for the opposite rear wheel.
4. To reinstall the rear wheel onto the axle bushing, reverse STEPS 1‐3.
Quick-Release Axle
Axle Bushing
Rear Wheel
Quick Release Axle

Adjusting Quick-Release Axles

NOTE: For this procedure, refer to FIGURE 11.2.
1. Remove rear wheel and quick/quad‐release axle from the wheelchair. Refer to
Removing/Installing Rear Wheels on page 67.
2. Depress detent pin in the quick‐release axle and slide axle through the wheel hub.
3. Release detent pin ensuring that the locking pins are fully released.
4. Increase or decrease end play by adjusting the locknut on the end of the quick‐release
axle.
WARNING
Make sure the detent pin and locking
pins of the quick-release axle are fully
released before operating wheelchair.
Keep locking pins clean.
5. Reinstall rear wheel onto the
wheelchair. Refer to
Removing/Installing Rear Wheels on
page 67.
ProSPIN™ X4™
FIGURE 11.1 Removing/Installing Rear Wheels
Permanent Axle
Axle Bushing
Mounting Bolt
Axle Mounting Plate
Locking
Pins
Quick-Release Axle
FIGURE 11.2 Adjusting Quick-Release
68
Locknut
Rear
Wheel
Locknut
Detent
Pin
Wheel Hub
Axles
Part No 1125104