Converting From Pull-To-Lock To Push-To-Lock - Invacare ProSPIN X4 Owner's Manual

NOTE: As the wheel lock handle is pushed downwards, the wheel lock will engage and then
disengage the wheel.
2. Push wheel lock handle down to access the upper stop position (Detail "B").
3. Install set screw into upper stop position.
4. Pull wheel lock handle up to engage wheel lock. If wheel lock does not properly
engage the wheel, refer to Adjusting the Wheel Lock on page 37.

Converting From Pull-to-Lock to Push-to-Lock

1. Remove set screw from the upper stop position (Detail "B").
NOTE: As the wheel lock handle is pulled upwards, the wheel lock will engage and then disengage
the wheel.
2. Pull wheel lock handle up to access the lower stop position (Detail "A").
3. Install set screw into lower stop position.
4. Push wheel lock handle down to engage wheel lock. If wheel lock does not properly
engage the wheel, refer to Adjusting the Wheel Lock on page 37.
DETAIL "A" WHEEL LOCK IN
PUSH-TO-LOCK CONFIGURATION
Wheel Lock Handle
(in Lower Stop Position)
FIGURE 6.3 Converting Wheel Lock From Push-to-Lock to Pull-to-Lock or Pull-to-Lock to
Part No 1125104
Set Screw
Push-to-Lock
39
SECTION 6—WHEEL LOCKS
DETAIL "B" WHEEL LOCK IN
PULL-TO-LOCK CONFIGURATION
Set Screw
(in Upper Stop Position)
Wheel Lock Handle
ProSPIN™ X4™