Adjusting Swingaway Padded Armrest Height
NOTE: For this procedure, refer to FIGURE 2.
1. Remove the half arm from the arm socket.
2. Remove the mounting bolt, two washers and locknut mounted in the arm socket that
determine the swingaway padded armrest height.
3. Reposition mounting bolt and one washer to one of three positions in the arm socket
depending on the desired height.
4. Retighten the mounting bolt and washer to the arm socket with the remaining washer
and locknut.
5. Reinstall the half arm into the arm socket.
6. Repeat STEPS 1‐5 for the opposite side, if necessary.
Swingaway Padded Armrest
Locknut
Three Mounting Positions
FIGURE 2 Adjusting Swingaway Padded Armrest Height
Part No 1134872
Washer
29
Arm Socket
Washer
Mounting Bolt
Crossfire
Arms
™
Series Wheelchairs