Link-Aggregation Port-Priority - HP 6125XLG Command Reference Manual

Default
An aggregation group operates in static aggregation mode.
Views
Aggregate interface view
Predefined user roles
network-admin
Examples
# Configure the aggregation group that corresponds to Bridge-Aggregation 1 to operate in dynamic
aggregation mode.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] link-aggregation mode dynamic

link-aggregation port-priority

Use link-aggregation port-priority to set the port priority of an interface.
Use undo link-aggregation port-priority to restore the default setting.
Syntax
link-aggregation port-priority port-priority
undo link-aggregation port-priority
Default
The port priority of an interface is 32768.
Views
Ethernet interface view
Predefined user roles
network-admin
Parameters
port-priority: Specifies the port priority in the range of 0 to 65535. The smaller the value, the higher the
port priority.
Examples
# Set the port priority of Ethernet interface Ten-GigabitEthernet 1/1/5 to 64.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/1/5
[Sysname-Ten-GigabitEthernet1/1/5] link-aggregation port-priority 64
Related commands
lacp system-priority
85