Port Hybrid Pvid - HP 6125XLG Command Reference Manual

Examples
# Assign FortyGigE 1/1/1 to VLAN 3.
<Sysname> system-view
[Sysname] vlan 3
[Sysname-vlan3] quit
[Sysname] interface fortygige 1/1/1
[Sysname-FortyGigE1/1/1] port access vlan 3

port hybrid pvid

Use port hybrid pvid to configure the PVID of the hybrid port.
Use undo port hybrid pvid to restore the default.
Syntax
port hybrid pvid vlan vlan-id
undo port hybrid pvid
Default
The PVID of a hybrid port is VLAN 1.
Views
Ethernet interface view, aggregate interface view, S-channel interface view
Predefined user roles
network-admin
Parameters
vlan-id: Specifies a VLAN ID in the range of 1 to 4094.
Usage guidelines
You can use a nonexistent VLAN as the PVID for a hybrid port. If you remove the PVID of a hybrid port
with the undo vlan command, the setting of the PVID on the port is not affected.
HP recommends that you set the same PVID for the local and remote hybrid ports.
You must configure the hybrid port to allow and forward packets from the PVID by using the port hybrid
vlan command.
The configuration made in Ethernet interface view applies only to the port.
•
• The configuration made in aggregate interface view applies to the aggregate interface and its
aggregation member ports.
If the system fails to apply the configuration to the aggregate interface, it stops applying the
configuration to aggregation member ports.
If the system fails to apply the configuration to an aggregation member port, it skips the port
and moves to the next member port.
The configuration made in S-channel interface view applies only to the interface.
•
Examples
# Configure VLAN 100 as the PVID of the hybrid port FortyGigE 1/1/1, and assign FortyGigE 1/1/1
to VLAN 100 as an untagged member.
<Sysname> system-view
157