HP 6125XLG Command Reference Manual page 15

Field
Unknown-speed mode
unknown-duplex mode
Link speed type is autonegotiation
Link speed type is force link
link duplex type is autonegotiation
link duplex type is force link
The Maximum Frame Length
Broadcast MAX-
Multicast MAX-
Unicast MAX-
PVID
Port link-type
Tagged Vlan
UnTagged Vlan
Last clearing of counters
Peak value of output
Peak time of output
Last 300 seconds input: 0 packets/sec 0
bytes/sec -%
Last 300 seconds output: 0 packets/sec
0 bytes/sec -%
Input(total): 0 packets, 0 bytes
0 unicasts, 0 broadcasts, 0
multicasts, 0 pauses
Description
Indicate that the rate of the interface is unknown. The reason might
be that the speed negotiation fails or the physical interface is
disconnected.
Indicate that the duplex mode of the interface is unknown. The
reason might be that the duplex mode negotiation fails or the
physical interface is disconnected.
The interface will negotiate a speed with its peer.
The speed of the interface is configured as a specific value, for
example, 1000 Mbps.
The interface will negotiate a duplex mode with its peer.
The interface is configured to operate in a specific duplex mode, for
example, full duplex mode.
Maximum Ethernet frame length allowed on the interface.
Broadcast storm suppression threshold, in percent, pps, or kbps
depending on your configuration.
Multicast storm suppression threshold, in percent, pps, or kbps
depending on your configuration.
Unknown unicast storm suppression threshold, in percent, pps, or
kbps depending on your configuration.
Port VLAN ID (PVID) of the Ethernet interface.
Link type of the interface, which can be access, trunk, or hybrid.
VLANs for which the interface sends packets without removing
VLAN tags.
VLANs for which the interface sends packets after removing VLAN
tags.
Time when the reset counters interface command was last used to
clear statistics on the interface. Never indicates that the reset
counters interface command was never used since the device was
started.
Peak value of inbound traffic (in Bps), and time of peak inbound
traffic.
Peak value of outbound traffic (in Bps), and time of peak outbound
traffic.
Average rate of input and output traffic in the last 300 seconds, in
pps and Bps, and the ratio of the actual rate to the maximum
interface rate in %.
A hyphen (-) indicates that the item is not supported.
Inbound traffic statistics (in packets and bytes) for the interface. All
inbound normal and abnormal packets and normal pause frames
were counted.
The number of inbound unicast packets, the number of inbound
broadcasts, the number of inbound multicasts, and the number of
inbound pause frames.
A hyphen (-) indicates that the item is not supported.
8