Flow-Control; Flow-Control Receive Enable - HP 6125XLG Command Reference Manual

Examples
# Configure interface Ten-GigabitEthernet 1/1/5 to operate in full duplex mode.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/1/5
[Sysname-Ten-GigabitEthernet1/1/5] duplex full

flow-control

Use flow-control to enable TxRx mode generic flow control on an Ethernet interface.
Use undo flow-control to disable generic flow control on the Ethernet interface.
Syntax
flow-control
undo flow-control
Default
Generic flow control is disabled on an Ethernet interface.
Views
Ethernet interface view
Predefined user roles
network-admin
Usage guidelines
To implement flow control on a link, enable the generic flow control function at both ends of the link.
TxRx mode generic flow control enables an Ethernet interface to receive common pause frames from its
peer, and send common pause frames to notify its peer of congestions.
With the flow-control command configured, an interface can both send and receive flow control frames:
When congested, the interface sends a flow control frame to its peer.
•
• Upon receiving a flow control frame from the peer, the interface suspends sending packets.
Examples
# Enable TxRx mode generic flow control on the interface Ten-GigabitEthernet 1/1/5.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/1/5
[Sysname-Ten-GigabitEthernet1/1/5] flow-control

flow-control receive enable

Use flow-control receive enable to enable Rx mode generic flow control on an Ethernet port.
Use undo flow-control to disable generic flow control on an Ethernet interface.
Syntax
flow-control receive enable
undo flow-control
17