Stp Compliance - HP 6125XLG Command Reference Manual

Default
The network diameter of the switched network is 7.
Views
System view
Predefined user roles
network-admin
Parameters
diameter: Specifies the switched network diameter in the range of 2 to 7.
Usage guidelines
An appropriate setting of hello time, forward delay, and max age can speed up network convergence.
The values of these timers are related to the network size, and you can set the timers by setting the
network diameter. With the network diameter set to 7 (the default), the three timers are also set to their
defaults.
Each MST region is considered a device, and the configured network diameter of the switched network
takes effect only on the CIST (or MSTI 0) but not on other MSTIs.
Examples
# In MSTP mode, set the network diameter of the switched network to 5.
<Sysname> system-view
[Sysname] stp bridge-diameter 5
Related commands
• stp timer forward-delay
stp timer hello
•
stp timer max-age
•

stp compliance

Use stp compliance to configure the mode the specified ports will use to recognize and send MSTP
BPDUs.
Use undo stp compliance to restore the default.
Syntax
stp compliance { auto | dot1s | legacy }
undo stp compliance
Default
A port automatically recognizes the formats of received MSTP packets and determines the formats of
MSTP packets to be sent based on the recognized formats.
Views
Ethernet interface view, aggregate interface view
Predefined user roles
network-admin
113