Stp Port-Log - HP 6125XLG Command Reference Manual

Parameters
instance instance-list: Sets the priority of the ports in the MSTIs that are specified by an instance list, in the
format of instance-list = { instance-id [ to instance-id ] }&<1- 1 0>, where &<1- 1 0> indicates that you can
specify up to 10 instances or instance ranges. The value range for the instance-id argument is 0 to 4094,
and the value 0 represents the CIST.
priority: Specifies the port priority in the range of 0 to 240 in increments of 16 (as in 0, 16, 32).
Usage guidelines
The smaller the value, the higher the port priority. If all ports on your device use the same priority value,
the port priority depends on the port index. The smaller the index, the higher the priority.
When the setting is configured in Ethernet interface view, it takes effect on only that interface.
When the setting is configured in aggregate interface view, it takes effect on only the aggregate
interface.
When the setting is configured on a member port in an aggregation group, it takes effect only after the
port leaves the aggregation group.
Examples
# In MSTP mode, set the priority of port FortyGigE 1/1/3 to 16 in MSTI 2.
<Sysname> system-view
[Sysname] interface fortygige 1/1/3
[Sysname-FortyGigE1/1/3] stp instance 2 port priority 16
Related commands
display stp

stp port-log

Use stp port-log to enable outputting port state transition information for the specified MSTI or for all
MSTIs.
Use undo stp port-log to disable outputting port state transition information for the specified MSTI or for
all MSTIs.
Syntax
stp port-log { all | instance instance-list }
undo stp port-log { all | instance instance-list }
Default
This function is disabled.
Views
System view
Predefined user roles
network-admin
Parameters
all: Specifies all MSTIs.
126