Lldp Commands; Dcbx Version; Display Lldp Local-Information - HP 6125XLG Command Reference Manual

LLDP commands

dcbx version

Use dcbx version to configure the DCBX version.
Use undo dcbx version to restore the default.
Syntax
dcbx version { rev100 | rev101 }
undo dcbx version
Default
The DCBX version is autonegotiated by two interfaces, with DCBX Rev 1.01 as the initial version for
negotiation at the local end.
Views
Layer 2 Ethernet interface view
Predefined user roles
network-admin
Parameters
rev100: Specifies DCBX version Rev 1.00.
rev101: Specifies DCBX version Rev 1.01.
Usage guidelines
To make sure DCBX operates correctly, you must configure the same DCBX version that is supported on
both ends. H3C recommends that you configure the highest version (Rev 1.01, Rev 1.00 in descending
order) that is supported on both ends.
After this command is configured, an interface includes the configured DCBX version in its outgoing
LLDPDUs and does not negotiate the DCBX version with the peer interface.
Examples
# Configure the DCBX version as DCBX Rev 1.01 on interface TwentyGigE 1/0/1.
<HP> system-view
[HP] interface twentygige 1/0/1
[HP-TwentyGigE1/0/1] dcbx version rev101

display lldp local-information

Use display lldp local-information to display the LLDP information to be sent, which will be contained in
the LLDP TLVs and sent to neighboring devices.
Syntax
display lldp local-information [ global | interface interface-type interface-number ]
172