HP 6125XLG Command Reference Manual page 209

dot1-tlv: Advertises IEEE 802.1 organizationally specific LLDP TLVs.
dcbx: Advertises the Data Center Bridging Exchange Protocol (DCBX) TLV.
port-vlan-id: Advertises port VLAN ID TLVs.
protocol-vlan-id [ vlan-id ]: Advertises port and protocol VLAN ID TLVs. The vlan-id argument specifies a
VLAN ID in the TLVs to be advertised. The VLAN ID is in the range of 1 to 4094, and the default is the
lowest VLAN ID on the port.
vlan-name [ vlan-id ]: Advertises VLAN name TLVs. The vlan-id argument specifies a VLAN ID in the TLVs
to be advertised. The VLAN ID is in the range of 1 to 4094, and the default is the lowest VLAN ID on the
port.
dot3-tlv: Advertises IEEE 802.3 organizationally specific LLDP TLVs.
link-aggregation: Advertises link aggregation TLVs.
mac-physic: Advertises MAC/PHY configuration/status TLVs.
max-frame-size: Advertises maximum frame size TLVs.
power: Advertises power in MDI TLVs and power stateful control TLVs.
med-tlv: Advertises LLDP-MED TLVs.
capability: Advertises LLDP-MED capabilities TLVs.
inventory: Advertises the following TLVs: hardware revision, firmware revision, software revision, serial
number, manufacturer name, model name, and asset ID.
location-id: Advertises location identification TLVs.
civic-address: Inserts the normal address information about the network device in location identification
TLVs .
device-type: Sets a device type value in the range of 0 to 2. Value 0 specifies a DHCP server. Value 1
specifies a switch. Value 2 specifies an LLDP-MED endpoint.
country-code: Sets a country code, corresponding to ISO 3166.
{ ca-type ca-value }&<1- 1 0>: Configures address information, where ca-type represents the address
information type in the range of 0 to 255, ca-value represents address information, a string of 1 to 250
characters, and &<1- 1 0> indicates that you can specify up to 10 ca-type ca-value pairs.
elin-address: Inserts telephone numbers for emergencies in location identification TLVs.
tel-number: Sets the telephone number for emergencies, a string of 10 to 25 characters.
network-policy: Advertises network policy TLVs.
power-over-ethernet: Advertises extended power-via-MDI TLVs.
Usage guidelines
You can enable the device to advertise multiple types of TLVs by using this command without the all
keyword specified.
If the MAC/PHY configuration/status TLV is not advertisable, none of the LLDP-MED TLVs will be
advertised regardless of whether they are advertisable. If the LLDP-MED capabilities TLV is not
advertisable, the other LLDP-MED TLVs will not be advertised regardless of whether they are advertisable.
Examples
# Enable the device to advertise link aggregation TLVs of the IEEE 802.3 organizationally specific TLVs
on FortyGigE 1/1/1.
202