Vlan - HP 6125XLG Command Reference Manual

Default
A VLAN interface is not manually shut down. The VLAN interface is up if one or more ports in the VLAN
is up, and it goes down if all ports in the VLAN go down.
Views
VLAN interface view
Predefined user roles
network-admin
Usage guidelines
A VLAN interface that was shut down with the shutdown command remains in DOWN (Administratively)
state until you bring it up, regardless of how the state of the ports in the VLAN changes.
Before you configure parameters for a VLAN interface, shut down the VLAN interface with the shutdown
command to prevent the configurations from affecting the network. You can use the undo shutdown
command to bring up a VLAN interface after you have configured related parameters and protocols for
the VLAN interface.
You can shut down a failed interface with the shutdown command and then bring it up with the undo
shutdown command to see whether it recovers.
In a VLAN, the state of any Ethernet port is independent of the state of the VLAN interface.
Examples
# Shut down VLAN interface 2, and then cancel the action of manually shutting down the VLAN
interface.
<Sysname> system-view
[Sysname] interface vlan-interface 2
[Sysname-Vlan-interface2] shutdown
[Sysname-Vlan-interface2] undo shutdown

vlan

Use vlan vlan-id to create a VLAN and enter its view or to enter the view of an existing VLAN.
Use vlan vlan-id1 to vlan-id2 to create VLANs vlan-id1 through vlan-id2, except reserved VLANs.
Use vlan all to create VLANs 1 through 4094.
Use undo vlan to remove the specified VLANs.
Syntax
vlan { vlan-id1 [ to vlan-id2 ] | all }
undo vlan { vlan-id1 [ to vlan-id2 ] | all }
Default
VLAN 1 (the default VLAN) exists.
Views
System view
Predefined user roles
network-admin
153