Port Trunk Pvid - HP 6125XLG Command Reference Manual

Related commands
port link-type

port trunk pvid

Use port trunk pvid to configure the PVID for the trunk port.
Use undo port trunk pvid to restore the default.
Syntax
port trunk pvid vlan vlan-id
undo port trunk pvid
Default
The PVID of a trunk port is VLAN 1.
Views
Ethernet interface view, aggregate interface view, S-channel interface view
Predefined user roles
network-admin
Parameters
vlan-id: Specifies a VLAN ID in the range of 1 to 4094.
Usage guidelines
You can use a nonexistent VLAN as the PVID for a trunk port. If you remove the PVID of a trunk port with
the undo vlan command, the setting of the PVID on the port is not affected.
The local and remote trunk ports must use the same PVID for the packets of the PVID to be transmitted
correctly.
You must configure the trunk port to allow and forward packets from the PVID by using the port trunk
permit vlan command.
The configuration made in Ethernet interface view applies only to the port.
•
The configuration made in aggregate interface view applies to the aggregate interface and its
•
aggregation member ports.
If the system fails to apply the configuration to the aggregate interface, it stops applying the
configuration to aggregation member ports.
If the system fails to apply the configuration to an aggregation member port, it skips the port
and moves to the next member port.
The configuration made in S-channel interface view applies only to the interface.
•
Examples
# Configure VLAN 100 as the PVID of the trunk port FortyGigE 1/1/1, and assign FortyGigE 1/1/1 to
VLAN 100.
<Sysname> system-view
[Sysname] interface fortygige 1/1/1
[Sysname-FortyGigE1/1/1] port link-type trunk
[Sysname-FortyGigE1/1/1] port trunk pvid vlan 100
[Sysname-FortyGigE1/1/1] port trunk permit vlan 100
161