Configuring Isp Domain Attributes - HP 6125G Configuration Manual

Step
1. Enter system view.
2. Create an ISP domain and
enter ISP domain view.
3. Return to system view.
4. Specify the default ISP
domain.
NOTE:
To delete the ISP domain that is functioning as the default ISP domain, you must change it to a non-default
ISP domain by using the undo domain default enable command.

Configuring ISP domain attributes

In an ISP domain, you can configure the following attributes for all users in the domain:
• Domain status:
By placing the ISP domain to the active or blocked state, you allow or deny network service
requests from users in the domain.
Maximum number of online users:
•
The switch controls the number of online users in a domain to ensure the system performance and
service reliability.
Idle cut:
•
This function enables the switch to check the traffic of each online user in the domain at the idle
timeout interval, and to log out any user in the domain whose traffic during the idle timeout period
is less than the specified minimum traffic.
Self-service server location:
•
By using the information defined in this attribute, users can access the self-service server to manage
their own accounts and passwords.
Default authorization user profile:
•
If a user passes authentication but is authorized with no user profile, the switch authorizes the
default user profile of the ISP domain to the user and restricts the user's behavior based on the
profile.
To configure ISP domain attributes:
Step
1. Enter system view.
2. Enter ISP domain view.
3. Place the ISP domain to the
state of active or blocked.
Command
system-view
domain isp-name
quit
domain default enable
isp-name
Command
system-view
domain isp-name
state { active | block }
39
Remarks
N/A
N/A
N/A
Optional.
By default, the default ISP domain is the
system predefined ISP domain system.
Remarks
N/A
N/A
Optional.
By default, an ISP domain is in active
state, and users in the domain can
request network services.