Aaa For Telnet Users By Separate Servers - HP 6125G Configuration Manual

Verify the configuration:
2.
Telnet to the switch as a user and enter the correct username and password. You pass
authentication and log in to the switch. Issuing the display connection command on the switch, you
can see information about the user connection.

AAA for Telnet users by separate servers

Network requirements
As shown in
and RADIUS accounting services for Telnet users. Set the shared keys for secure communication with the
HWTACACS server and the RADIUS server to expert. Configure the switch to remove the domain name
from a username before sending the username to the servers.
Figure 11 Network diagram
Configuration procedure
Configure the switch:
1.
# Assign IP addresses to interfaces. (Details not shown.)
# Enable the Telnet server on the switch.
<Switch> system-view
[Switch] telnet server enable
# Configure the switch to use AAA for Telnet users.
[Switch] user-interface vty 0 4
[Switch-ui-vty0-4] authentication-mode scheme
[Switch-ui-vty0-4] quit
# Configure the HWTACACS scheme.
[Switch] hwtacacs scheme hwtac
[Switch-hwtacacs-hwtac] primary authorization 10.1.1.2 49
[Switch-hwtacacs-hwtac] key authorization expert
[Switch-hwtacacs-hwtac] user-name-format without-domain
[Switch-hwtacacs-hwtac] quit
# Configure the RADIUS scheme.
[Switch] radius scheme rd
[Switch-radius-rd] primary accounting 10.1.1.1 1813
[Switch-radius-rd] key accounting expert
[Switch-radius-rd] server-type extended
[Switch-radius-rd] user-name-format without-domain
Figure 1 1, configure the switch to provide local authentication, HWTACACS authorization,
47