Configuring Isp Domain Attributes - HP 3600 v2 Series Configuration Manual

Step
2. Create an ISP domain and
enter ISP domain view.
3. Return to system view.
4. Specify the default ISP
domain.
NOTE:
To delete the ISP domain that is functioning as the default ISP domain, you must change it to a non-default
ISP domain by using the undo domain default enable command.

Configuring ISP domain attributes

In an ISP domain, you can configure the following attributes:
Domain status—By placing the ISP domain to the active or blocked state, you allow or deny
•
network service requests from users in the domain.
Maximum number of online users—The switch controls the number of online users in a domain to
•
ensure the system performance and service reliability.
Idle cut—This function enables the switch to check the traffic of each online user in the domain at the
•
idle timeout interval, and to log out any user in the domain whose traffic during the idle timeout
period is less than the specified minimum traffic.
Self-service server location—By using the information defined in this attribute, users can access the
•
self-service server to manage their own accounts and passwords. A self-service RADIUS server, such
as IMC, is required for the self-service server location function to work.
• Default authorization user profile—If a user passes authentication but is authorized with no user
profile, the switch authorizes the default user profile of the ISP domain to the user and restricts the
user's behavior based on the profile. For more information about user profiles, see
user profile."
DSCP value—The switch sets the specified DSCP value in IP packets from authenticated users in the
•
ISP domain, which is identified in the login username userid@domain-name. Policy-based routing
routes IP packets to different destinations based on the DSCP value. This attribute applies only to ISP
domains that use the same scheme for Layer 3 portal authentication. For more information about
policy-based routing, see Layer 3—IP Routing Configuration Guide. For more information about
Layer 3 portal authentication, see
To configure ISP domain attributes:
Step
1. Enter system view.
2. Enter ISP domain view.
3. Place the ISP domain to the
state of active or blocked.
Command
domain isp-name
quit
domain default enable
isp-name
"Configuring portal
Command
system-view
domain isp-name
state { active | block }
42
Remarks
N/A
N/A
Optional.
By default, the default ISP domain is the
system-defined ISP domain system.
authentication."
Remarks
N/A
N/A
Optional.
By default, an ISP domain is in active
state, and users in the domain can
request network services.
"Configuring a