User Validity Check Configuration Example - HP 6125G Configuration Manual

User validity check configuration example

Network requirements
As shown in
for connected hosts.
Figure 74 Network diagram
Configuration procedure
Add all the ports on Switch B into VLAN 10, and configure the IP address of VLAN-interface 10 on
1.
Switch A. (Details not shown.)
Configure Switch A as a DHCP server:
2.
# Configure DHCP address pool 0.
<SwitchA> system-view
[SwitchA] dhcp enable
[SwitchA] dhcp server ip-pool 0
[SwitchA-dhcp-pool-0] network 10.1.1.0 mask 255.255.255.0
Configure Host A and Host B as 802.1X clients and configure them to upload IP addresses for ARP
3.
detection. (Details not shown.)
Configure Switch B:
4.
# Enable the 802.1X function.
<SwitchB> system-view
[SwitchB] dot1x
[SwitchB] interface gigabitethernet 1/0/1
[SwitchB-GigabitEthernet1/0/1] dot1x
[SwitchB-GigabitEthernet1/0/1] quit
[SwitchB] interface gigabitethernet 1/0/2
[SwitchB-GigabitEthernet1/0/2] dot1x
[SwitchB-GigabitEthernet1/0/2] quit
# Add local access user test.
[SwitchB] local-user test
[SwitchB-luser-test] service-type lan-access
Figure 74, configure Switch B to perform user validity check based on 802.1X security entries
244