HP 6125G Configuration Manual page 220

Input the bits of the modulus[default = 1024]:
Generating Keys...
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
+++++++++++++++++++++++++++++++++++
# Enable the SSH server.
[Switch] ssh server enable
# Enable the SFTP server.
[Switch] sftp server enable
# Configure an IP address for VLAN-interface 1, which the client will use as the destination for SSH
connection.
[Switch] interface vlan-interface 1
[Switch-Vlan-interface1] ip address 192.168.1.45 255.255.255.0
[Switch-Vlan-interface1] quit
# Set the authentication mode of the user interfaces to AAA.
[Switch] user-interface vty 0 7
[Switch-ui-vty0-7] authentication-mode scheme
# Enable the user interfaces to support SSH.
[Switch-ui-vty0-7] protocol inbound ssh
[Switch-ui-vty0-7] quit
# Configure a local user named client002 with the password being aabbcc and the service type
being SSH.
[Switch] local-user client002
[Switch-luser-client002] password simple aabbcc
[Switch-luser-client002] service-type ssh
[Switch-luser-client002] quit
# Configure the user authentication method as password and service type as SFTP.
[Switch] ssh user client002 service-type sftp authentication-type password
Establish a connection between the SFTP client and the SFTP server:
2.
The switch supports a variety of SFTP client software. The following example uses PSFTP of PuTTy
Version 0.58.
NOTE:
PSFTP supports only password authentication.
To establish a connection to the remote SFTP server:
Run the psftp.exe to launch the client interface as shown in
a.
command:
open 192.168.1.45
Enter username client002 and password aabbcc as prompted to log in to the SFTP server.
b.
210
Figure 62, and enter the following