HP 6125G Configuration Manual page 35

servers in active state. If no other servers are in active state at the time, it considers the authentication or
accounting attempt a failure. For more information about RADIUS server states, see
RADIUS servers."
To set the maximum number of RADIUS request transmission attempts for a scheme:
Step
1. Enter system view.
2. Enter RADIUS scheme view.
3. Set the maximum number of
RADIUS request transmission
attempts.
NOTE:
• The maximum number of transmission attempts of RADIUS packets multiplied by the RADIUS server
response timeout period cannot be greater than 75 seconds.
For more information about the RADIUS server response timeout period, see
•
controlling communication with RADIUS
Setting the status of RADIUS servers
By setting the status of RADIUS servers to blocked or active, you can control which servers the switch
communicates with for authentication, authorization, and accounting or turn to when the current servers
are no longer available. In practice, you can specify one primary RADIUS server and multiple secondary
RADIUS servers, with the secondary servers functioning as the backup of the primary servers. Generally,
the switch chooses servers based on these rules:
When the primary server is in active state, the switch communicates with the primary server. If the
•
primary server fails, the switch changes the server's status to blocked and starts a quiet timer for the
server, and then turns to a secondary server in active state (a secondary server configured earlier
has a higher priority). If the secondary server is unreachable, the switch changes the server's status
to blocked, starts a quiet timer for the server, and continues to check the next secondary server in
active state. This search process continues until the switch finds an available secondary server or
has checked all secondary servers in active state. If the quiet timer of a server expires or an
authentication or accounting response is received from the server, the status of the server changes
back to active automatically, but the switch does not check the server again during the
authentication or accounting process. If no server is found reachable during one search process,
the switch considers the authentication or accounting attempt a failure.
Once the accounting process of a user starts, the switch keeps sending the user's real-time
•
accounting requests and stop-accounting requests to the same accounting server. If you remove the
accounting server, real-time accounting requests and stop-accounting requests for the user are no
longer delivered to the server.
• If you remove an authentication or accounting server in use, the communication of the switch with
the server soon times out, and the switch looks for a server in active state from scratch by checking
any primary server first and then secondary servers in the order they are configured.
When the primary server and secondary servers are all in blocked state, the switch communicates
•
with the primary server. If the primary server is available, its status changes to active. Otherwise, its
status remains to be blocked.
Command
system-view
radius scheme
radius-scheme-name
retry retry-times
servers."
25
"Setting the status of
Remarks
N/A
N/A
Optional.
The default setting is 3.
"Setting timers for