HP 6125G Configuration Manual page 239

On port GigabitEthernet 1/0/1 of Device A, only IP packets from Host A can pass.
•
• On port GigabitEthernet 1/0/2 of Device B, only IP packets from Host A can pass.
On port GigabitEthernet 1/0/1 of Device B, only IP packets sourced from 192.168.0.2/24 can
•
pass. Host B can communicate with Host A by using this IP address even if it uses another network
adapter.
Figure 69 Network diagram
Configuration procedure
Configure Device A:
1.
# Configure the IPv4 source guard function on GigabitEthernet 1/0/2 to filter packets based on
both the source IP address and MAC address.
<DeviceA> system-view
[DeviceA] interface gigabitethernet 1/0/2
[DeviceA-GigabitEthernet1/0/2] ip verify source ip-address mac-address
# Configure GigabitEthernet 1/0/2 to allow only IP packets with the source MAC address of
0001-0203-0405 and the source IP address of 192.168.0.3 to pass.
[DeviceA] interface gigabitethernet 1/0/2
[DeviceA-GigabitEthernet1/0/2] ip source binding ip-address 192.168.0.3 mac-address
0001-0203-0405
[DeviceA-GigabitEthernet1/0/2] quit
# Configure the IPv4 source guard function on GigabitEthernet 1/0/1 to filter packets based on
both the source IP address and MAC address.
[DeviceA] interface gigabitethernet 1/0/1
[DeviceA-GigabitEthernet1/0/1] ip verify source ip-address mac-address
# Configure GigabitEthernet 1/0/1 to allow only IP packets with the source MAC address of
0001-0203-0406 and the source IP address of 192.168.0.1 to pass.
[DeviceA-GigabitEthernet1/0/1] ip source binding ip-address 192.168.0.1 mac-address
0001-0203-0406
[DeviceA-GigabitEthernet1/0/1] quit
Configure Device B:
2.
# Configure the IPv4 source guard function on GigabitEthernet 1/0/2 to filter packets based on
both the source IP address and MAC address.
<DeviceB> system-view
[DeviceB] interface gigabitethernet 1/0/2
[DeviceB-GigabitEthernet1/0/2] ip verify source ip-address mac-address
229