HP 6125G Configuration Manual page 39

Step
1. Enter system view.
2. Enter RADIUS scheme
view.
3. Enable accounting-on and
configure parameters.
NOTE:
The accounting-on feature requires the cooperation of the HP IMC network management system.
Configuring the IP address of the security policy server
The core of the HP EAD solution is integration and cooperation, and the security policy server is the
management and control center. Using a collection of software, the security policy server provides
functions such as user management, security policy management, security status assessment, security
cooperation control, and security event audit.
The NAS checks the validity of received control packets and accepts only control packets from known
servers. To use a security policy server that is independent of the AAA servers, you must configure the IP
address of the security policy server on the NAS. To implement all EAD functions, configure both the IP
address of the security policy server and that of the IMC Platform on the NAS.
To configure the IP address of the security policy server for a scheme:
Step
1. Enter system view.
2. Enter RADIUS scheme
view.
3. Specify a security policy
server.
Configuring interpretation of RADIUS class attribute as CAR parameters
According to RFC 2865, a RADIUS server assigns the RADIUS class attribute (attribute 25) to a RADIUS
client. However, the RFC only requires the RADIUS client to send the attribute to the accounting server on
an "as is" basis. It does not require the RADIUS client to interpret the attribute. Some RADIUS servers use
the class attribute to deliver the assigned committed access rate (CAR) parameters. In this case, the
switch must interpret the attribute as the CAR parameters to implement user-based traffic monitoring and
controlling.
To configure the switch to interpret the RADIUS class attribute as CAR parameters:
Step
1. Enter system view.
2. Enter RADIUS scheme view.
3. Interpret the class attribute as
CAR parameters.
Command
system-view
radius scheme
radius-scheme-name
accounting-on enable
[ interval seconds | send
send-times ] *
Command
system-view
radius scheme radius-scheme-name
security-policy-server ip-address
Command
system-view
radius scheme
radius-scheme-name
attribute 25 car
29
Remarks
N/A
N/A
Disabled by default.
The default interval is 3 seconds and the
default number of send-times is 50.
Remarks
N/A
N/A
No security policy server is
specified by default.
Remarks
N/A
N/A
By default, RADIUS attribute 25 is not
interpreted as CAR parameters.