Isolate-User-Vlan Configuration Example - HP 5820X series Configuration Manual

Isolate-user-VLAN configuration example

Network requirements
As shown in Figure
Connect Device A to downstream devices Device B and Device C.
•
Configure VLAN 5 on Device B as an isolate-user-VLAN, assign the uplink port GigabitEthernet
•
1/0/5 to VLAN 5, and associate VLAN 5 with secondary VLANs VLAN 2 and VLAN 3. Assign
GigabitEthernet 1/0/2 to VLAN 2 and GigabitEthernet 1/0/1 to VLAN 3.
Configure VLAN 6 on Device C as an isolate-user-VLAN, assign the uplink port GigabitEthernet
•
1/0/5 to VLAN 6, and associate VLAN 6 with secondary VLANs VLAN 3 and VLAN 4. Assign
GigabitEthernet 1/0/3 to VLAN 3 and GigabitEthernet 1/0/4 to VLAN 4.
As far as Device A is concerned, Device B only has VLAN 5 and Device C has only VLAN 6.
•
Figure 43 Network diagram
Configuration procedure
The following part provides only the configuration on Device B and Device C.
Configure Device B.
1.
# Configure the isolate-user-VLAN.
<DeviceB> system-view
[DeviceB] vlan 5
[DeviceB-vlan5] isolate-user-vlan enable
[DeviceB-vlan5] quit
43,
135