Kyocera TASKalfa 4501i Operation Manual page 273

Using Various Functions > Functions
Mixed Size Stapling
Even with mixed paper sizes, if the sizes have the same width or same length as shown in the combinations below, the
output can be stapled. Up to 30 sheets can be stapled.
A4 A3
B5 B4
Letter Ledger
A4 A3
B5 B4
Letter Ledger
Letter-R Legal
Letter-R Legal
NOTE
When performing Mixed Size Stapling, refer to
Punch
Punches holes in sets of finished documents.
NOTE
• The optional document finisher (1,000-Sheet Finisher or 4,000-Sheet Finisher) and punching unit are required.
• For details on paper sizes that can be punched, refer to
• The inch model provides two-hole and three-hole punching. The metric model provides two-hole and four-hole
punching.
Item
Punch 2 holes Left
2 holes Top
2 holes Right
3 holes Left
3 holes Top
3 holes Right
4 holes Left
4 holes Top
4 holes Right
Original Top Edge on Top, Top Edge on Left
Orientation
•
•
•
•
•
Mixed Size Originals on page
Hole Punch Unit (Option) on page
Value
6-19
A3 and A4
B4 and B5
Ledger and Letter
Ledger and Letter-R
8K and 16K
6-13.
Description
Select the position of punch holes. For details on original
orientation and position of punch holes, refer to
Orientation and Punch Hole Position on page
Select the orientation of the original document top edge to
scan correct direction. Press [Original Orientation] to choose
orientation of the originals, either [Top Edge on Top] or [Top
Edge on Left]. Then press [OK].
11-29.
Original
6-20.