Sleep And Auto Sleep - Kyocera TASKalfa 4501i Operation Manual

Preparation before Use > Energy Saver function

Sleep and Auto Sleep

Sleep
To enter Sleep, press the [Power] key. Touch panel and all indicators on the operation panel will go out to save a
maximum amount of power except the Main Power indicator. This status is referred to as Sleep.
If print data is received during Sleep, the print job is performed while the touch panel remains unlit.
When using the optional fax, received fax data is printed out while the operation panel also remains unlit.
• Press the touch panel or any key on the operation panel.
The machine will be ready to operate within 16 seconds.
Note that ambient environmental conditions, such as ventilation, may cause the machine to respond more slowly.
Auto Sleep
Auto Sleep automatically switches the machine into Sleep if left idle for a preset time in the Low Power Mode.
The default preset time are 45 minutes for 3501i, and 60 minutes for 4501i/5501i.
To change the preset sleep time, refer to
Sleep Level (Energy Saver)
This mode reduces power consumption even more than normal Sleep mode, and allows Sleep Mode to be set
separately for each function. Printing from a computer connected with a USB cable is not available while the machine is
asleep. The time required for the machine to wake up from power save mode and resume normal operation will be
longer than for normal Sleep Mode.
NOTE
If the optional network interface kit is installed, Energy Saver cannot be specified.
For more information on Energy Saver Mode settings, refer to
Energy Saver Recovery Level
This machine can reduce power consumption when recovering from Energy Saver Mode.
For EnergySaver RecoveryLevel, "Full Recovery", "Normal Recovery" or "Power Saving Recovery" can be selected.
The factory default is "Normal Recovery".
For more information on Energy Saver Mode settings, refer to
Sleep Timer on page 8-55.
Sleep Level on page
EnergySaver RecoveryLevel on page
3-15
Main Power
indicator
8-55.
8-56.